Space Hardware Marketplace

CubeSat Kit Quad-switch Cover Plate Assembly

• MaterialAl 5052-H32, plated per CubeSat Design Specification (CDS)
• Mounting screwsFour M3 flathead stainless-steel screws
• Number of switchesFour independent separation/inhibit switches (3 usable on standard CubeSat Kit chassis; 4 on CubeSat Kit Pro)

A flight-qualified cover plate for CubeSat Kit structures permitting the use of up to four separation/inhibit switches, installable…

6U CubeSat Display Model

• Dimensionsapproximately 360.5 mm x 200 mm x 100 mm
• Form factor6U tabbed CubeSat
• Compatible dispensersRocket Lab CSD 6U, Maverick Space Systems (MSS) Mercury-6, and similar

A full-size (approximately 360.5mm x 200mm x 100mm) plastic display model of a 6U tabbed CubeSat compatible with…

CubeSat Kit for Microchip PIC24 MCUs

• MCUMicrochip PIC24FJ256GA110, low-power 16-bit
• Processor modulePluggable Socketed Processor Module D (PSPM D) with PIC24FJ256GA110
• Processor module variantPluggable Processor Module D1 (PPM D1)

Pumpkin's complete CubeSat bus kit built around the Microchip PIC24FJ256GA110 low-power 16-bit MCU, bundling structure, command & data…

3U CubeSat Display Model

• Dimensions340.5 mm x 100 mm x 100 mm
• Form factor3U CubeSat (per CubeSat Design Specification)
• ConstructionOne-piece plastic model, not intended to be disassembled

A full-size (340.5mm x 100mm x 100mm) plastic display model of a 3U CubeSat following the CubeSat Design…

104-pin Bus Reversing Adapter

• Connector104-pin CubeSat bus, stackthrough on one side, standard header on reversed side
• All pins passed through104 of 104 pins routed straight through
• Included hardware3D-printed plastic support arms, miscellaneous M3 fasteners

A development tool that allows a CubeSat Kit-compatible module to be installed upside-down on the 104-pin CubeSat bus,…

Development Board 2 (DB2)

• Bus connectorsTwo interconnected 104-pin CubeSat bus connectors with M3 standoffs
• Module stacks supportedTwo
• Debug header10-pin header for Total Phase I2C host adapters/protocol analyzers (I2C, first SPI bus signals, signal ground)

A simple development tool board for CubeSat modules conforming to the 104-pin CubeSat bus standard, used to characterize…

Lunar Rover Solar Panel

• Example configuration72-cell, 6x10S1P + 1x12S1P solar panel
• Example driven loadPumpkin EPSM 1 with two 100Wh BM2 battery modules (not included)
• RoutingSingle-layer maze routing, no vias

A custom PMDSAS solar array configured to the design constraints of a customer's lunar rover, with custom solar…

High-power Multi-channel Electrical Power System Module (EPSM1)

A high-performance, highly efficient FPGA-driven, GaNFET-based multichannel power system module for small satellites, handling up to 480W of…

135W Dual Articulated Deployable Solar Array

A compact, deployable 135W solar array with two single-motor Solar Array Drive Assemblies (SADAs) driving independently steerable 67W…

CubeSat Kit Large Aperture Base Plate Assembly, Dual Switch

• MaterialAl 5052-H32, plated per CubeSat Design Specification (CDS)
• Mounting screwsSix M3 flathead stainless-steel screws (to Chassis Walls)
• Switch configurationDual switch (2 deployment switch positions)

A precision Al 5052-H32 base plate assembly with dual deployment switches, used on the Motherboard Module (MBM) end…

2nd Switch (L2) Spring Upgrade Kit

• Applies to2nd switch (L2) on Pumpkin base plate assemblies
• Standard equipment as ofJanuary 1, 2017 (all CSK chassis assemblies)
• CompatibilityRev-E or later motherboard modules

A hardware upgrade kit adding spring strength to the 2nd switch (L2) on Pumpkin CubeSat Kit base plate…

220W Deployable Clamshell Solar Array (DCSA)

220W peak power deployable clamshell solar array for CubeSats and small satellites — 32.2% efficient triple-junction cells, 44…

Motherboard Module 2 (MBM2)

1 GHz ARM Cortex-A8 Linux on-board computer module for CubeSats with 4.5× UARTs, I2C, SPI, Ethernet, RS-422, and…

Intelligent Protected Lithium Battery Module with SoC Reporting (BM2)

Pumpkin's flight-qualified, protected lithium-ion battery module (BM2) with state-of-charge reporting, configurable cell topology and capacity, for CubeSats and…

Flight Switch Simulator Module

• Simulated RBF switches1
• Simulated Separation switchesUp to 3
• Switch logic combinationAND / OR via user-settable jumpers

A CubeSat Kit test module that simulates one Remove-Before-Flight switch and up to three separation switches, electrically compatible…

Load Module

A CubeSat Kit accessory module that exposes VBATT, +5V_SYS and VCC_SYS power buses on banana jacks and connectors…

USB Debug Adapter

A USB-to-serial debug adapter that provides a debugging terminal interface and optional power to Pumpkin CubeSat Kit modules…

Custom PMDSAS Panel, Deployable, per Cell

• TechnologyPumpkin Modular Deployable Solar Array System (PMDSAS)
• Mounting typeDeployable
• On-orbit heritage600+ panels flown since 2008, 100% on-orbit success rate, LEO to GTO

Custom deployable solar panels built with Pumpkin's Modular Deployable Solar Array System (PMDSAS) technology, priced per solar cell,…